3.
Option 2: Configure Network Port 1 with an IPv6 Address"
a.
Use the Configure IPv6 list to select DHCPv6, Stateless (SLAAC), or Static.
•
If you select the DHCPv6 option, for a successful startup, DHCPv6 must
be running on your network.
•
If you selected Static, you must enter the IPv6 Address, Prefix Length,
and Gateway.
b.
Verify the values are correct (you can change any incorrect value by tapping
the keyboard button). Tap Next.
Configure the Library Step 3 of 6: Set the Library Date and Time
Configure the library date and time to match the desired time zone.
1.
Set the library time zone:
a.
Select the Time Zone from the list.
b.
Select the Closest City or Region from the list.
c.
Tap Next.
2.
Configure the date and time by selecting either Manually or Using Network Time
Protocol from the list.
•
If you select Using Network Time Protocol, you must provide the IP address
of a Network Time Protocol server on your network. The steps are similar to
those for setting an IP address for Network Port 1.
•
If you select Manually, enter the current date in the format MM/DD/YYYY.
Enter the current time in the format HH:MM:SS where HH represents 24-hour
format.
3.
Verify the values are correct (change any incorrect value by tapping the keyboard
button). Tap Next.
Configure the Library Step 4 of 6: Set the Drive Element Addressing
Mode
The drive element addressing mode affects how the library assigns SCSI element IDs
to tape drives.
Note:
Code versions before 2.0 will not include this step.
Chapter 2
Configure the Library After Powering-on for the First Time
2-37
