Oracle SPARC T8-4, Service Manual

Page: 187 / 204

Install the Rear Chassis Subassembly
Install the Rear Chassis Subassembly
1. Slide the rear chassis subassembly into the server.
2. From the front of the server, tighten the five green screws that secure the rear
chassis subassembly in the server.
3.
Remove the connector covers from the replacement rear chassis subassembly.
4. Install the following components:
■
All four power supplies – see “Install a Power Supply” on page 142 .
■
Main module – see “Install the Main Module” on page 102 .
■
Both processor modules or processor filler modules – see . “Install a Processor Module or
Processor Filler Module” on page 63
5. Go to the rear of the server and install the following components:
■
Rear I/O module – see “Install the Rear I/O Module” on page 178 .
■
All PCIe carriers or fillers – see “Install a PCIe Card Carrier” on page 170 . Verify that you
are installing the PCIe cards back in their original slots using the notes that you took when
removing the cards from the slots earlier.
■
All five fan modules – see “Install a Fan Module” on page 151 .
Servicing the Rear Chassis Subassembly 187