Oracle SPARC T5-8, Service Manual

Page: 39 / 206

Configure POST
Detecting and Managing Faults 39
Configure POST
1. Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 28 .
2. Set the virtual keyswitch to the value that corresponds to the POST
configuration you want to run.
This example sets the virtual keyswitch to
normal
, which configures POST to run according to
other parameter values.
-> set /HOST keyswitch_state=normal
Set 'keyswitch_state' to 'Normal'
For possible values for the
keyswitch_state
parameter, see “Oracle ILOM Properties That
Affect POST Behavior” on page 35 .
3.
If the virtual keyswitch is set to
normal
, and you want to define the
mode
,
level
,
verbosity
, or
trigger
, set the respective parameters.
Syntax:
set /HOST/diag
property
=
value .
See “Oracle ILOM Properties That Affect POST Behavior” on page 35 for a list of
parameters and values.
Examples:
-> set /HOST/diag mode=normal
-> set /HOST/diag verbosity=max
4. View the current values for settings.
Example:
-> show /HOST/diag
/HOST/diag
Targets:
Properties:
error_reset_level = max
error_reset_verbosity = normal
hw_change_level = max
hw_change_verbosity = normal
level = min
mode = normal
power_on_level = max
power_on_verbosity = normal
trigger = hw_change error-reset
verbosity = normal