Oracle SPARC T5-2, Service Manual

Page: 95 / 186

Verify Power Supply Functionality
Verify Power Supply Functionality
1. Verify that the amber Service Required LED on the replaced power supply is not
lit.
2. Verify that the PS Fault LED on the front of the server is not lit.
3.
Use the Oracle ILOM
show faulty
command to verify that the fault has been
cleared.
See “Check for Faults” on page 46 for more information on using the
show faulty
command.
4.
Perform one of the following tasks based on your verification results:
■
If the previous steps did not clear the fault, see “Detecting and Managing Faults” on page 31
for information about the tools and methods you can use to diagnose component faults.
■
If the previous steps indicate that no faults have been detected, then the component has been
replaced successfully. No further action is required.
Related Information
■
“Locate a Faulty Power Supply” on page 91
■
“Front Panel Components (Service)” on page 13
■
“Rear Panel Components (Service)” on page 15
Servicing Power Supplies 95