Oracle SPARC M7, Service Manual, Page: 55 / 330

Clear a Fault Manually
See “Interpreting LEDs” on page 44 .
2. Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 67 .
3. Verify that the server is operating normally.
At the Oracle ILOM prompt, type:
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp> fmadm faulty
4.
Determine your next step.
■
If a fault was detected using the
fmadm faulty
command, see “Clear a Fault
Manually” on page 55 .
■
If no fault was detected, the component was installed successfully.
Related Information
■
“Identify Faulted Components” on page 36
■
“Clear a Fault Manually” on page 55
Clear a Fault Manually
When the server detects faults, the faults are logged and displayed on the console. In most
cases, after the fault is repaired, the corrected state is detected by the server, and the fault
condition is repaired automatically. In cases where the fault condition is not automatically
cleared, you must clear the fault manually.
1. After replacing a faulty component, power on the server, and verify that the fault
for that component has cleared.
See “Verify That a Fault Has Been Cleared” on page 54 .
2. Determine your next step.
■
If no fault was detected, you do not need to do anything else. Do not perform the subsequent
steps.
■
If a fault was detected, continue to the next step.
3. Clear the fault from all persistent fault records.
Detecting and Managing Faults 55