Oracle sparc M5-32, Installation Manual

Page: 152 / 182

142 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
Installed Software
The server is configured as a single PDomain containing all four DCUs. This
PDomain is preinstalled with the following software:
■
Oracle Solaris 11.1 OS
■
Oracle VM Server for SPARC software
■
Oracle VTS software
The two SPs are preinstalled with the Oracle ILOM firmware.
Refer to the SPARC M5-32 and SPARC M6-32 Servers Product Notes for the list of the
latest supported versions of the software and firmware.
Related Information
■
“Understanding the Firmware and Software Environment” on page 14
■
Oracle ILOM documentation
(http://www.oracle.com/goto/ILOM/docs)
■
Oracle Solaris 11.1 OS documentation
(http://www.oracle.com/goto/Solaris11/docs)
■
Oracle VTS documentation
(http://www.oracle.com/goto/VTS/docs)
■
Oracle VM Server for SPARC documentation
(http://www.oracle.com/goto/VM-SPARC/docs)
▼
Inspect the Power Cords
Inspect the power cords to ensure that they have been properly cabled to the server.
Note – Do not turn the circuit breakers to on until you have connected the SPs to
serial terminals or terminal emulators (PCs or workstations). If you power on the
server without first connecting terminal devices to the SER MGT ports, you will not
see the system power-on messages.
1. Confirm that the six power cords are securely attached to the AC input filters
located at the rear of the server and to the two facility power grids.
Each power cord must have its own circuit breaker between the server and the
facility AC power source.