To Connect the HBA to Internal Storage Devices
9
Edge of host board
Note -
The host adapter shape, size, and locations of components may vary from this
illustration.
4.
When the HBA is fully inserted in the slot, secure the HBA to the chassis of the
system by installing the bracket screw, if applicable, or by engaging the system
retention mechanism.
To Connect the HBA to Internal Storage Devices
1.
Configure and install the SAS devices, SATA devices, or both in the system.
For more information, see the documentation for the storage devices.
2.
Connect the serial SAS cables to the two internal x4 mini-SAS connectors and
attach the other end of the cables to the serial disk drives or other SAS/SATA
devices, per your requirements (
Figure 2, “Installing the HBA,” on page 19
Use only Oracle-provided SAS cables (provided with your system at time of purchase). You can
also purchase Oracle cables at
.
3.
Observe the light-emitting diodes (LEDs) during data transfer on the connected
drives to ensure normal operation of the HBA.
To Complete the Installation
1.
Replace the system cover and reconnect the AC power cords, as described in
the system documentation.
2.
If you needed to turn the system power off as part of the installation, turn power
on to the system.
Note -
Ensure that the power is turned on to the SAS devices, SATA II devices, or both before
or at the same time that the power is turned on to the host system. If the system is powered up
before these devices, the devices might not be recognized.
20
Sun Storage 6 Gb SAS PCIe HBA, Internal Installation Guide For HBA Models SGX-SAS6-INT-Z and SG-SAS6-INT-Z
• May 2017
Summary of Contents for SG-SAS6-INT-Z
Page 2: ......
