C
HAPTER
2
Set Up the Rack
About Component Inspection
Each Pillar Axiom 600 system is built to a customer's specifications and shipped
in a single shipment. Check the components you received against the packing
slip (or bill of lading), which lists everything that was shipped. If any components
are missing, call 1-877-4PILLAR (474-5527) and report what was not included in
your shipment. Note how many pallets or containers you received, in case the
missing components are in a container that simply has not yet arrived.
Caution
A Brick weighs up to 65 pounds (29.5 kilograms). For safe
handling, use two people to lift it.
Caution
A Slammer weighs 94 pounds (42.6 kilograms). For safe
handling, use two people to lift it.
Caution
Before you handle a component, make sure that you have
taken electrostatic discharge (ESD) precautions:
● The minimum requirement is an anti-static wrist strap
connected to a hard ground. Pillar recommends that
you remove components from their packaging and
place them on an ESD-qualified table that is equipped
with ground points for wrist straps.
● Static charges can build up rapidly on rolling carts. If
you transport a hardware component by cart, ground
the cart with a drag chain on an ESD floor. If there is
no ESD cart available or ESD floor, ground yourself
before you touch a component that has been
transported on a cart.
After you remove the components from their packaging, inspect them for any
damage that may have occurred during shipping. If there is any damage:
1 Check your Terms of Sale to see who notifies the carrier.
2 Notify the carrier or the Pillar World Wide Customer Support Center, as
appropriate, within 72 hours.
Chapter 2 Set Up the Rack
About Component Inspection
26