Oracle Fabric Interconnect F2-12, Installation Manual

Page: 37 / 118

Install the Cable Management Comb
Install the Cable Management Comb
1. Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See “Installation Task Overview” on page 11 .
2. Orient the upper mounting holes of the cable management comb to where you
just installed the 10-32 cage nuts.
3.
Using a No. 2 Philips screwdriver, secure the upper mounting holes of the cable
management comb to the 10-32 cage nuts with two 10-32 screws.
4.
Secure the lower mounting holes of the cable management comb to the hole in
the end center of the shelf rails with two 10-32 screws.
5.
Route the power cords and management cables.
See “Route the Power Cords and Management Cables” on page 38 .
Installing the Switch 37