Task
Command to Run on the
DCS Stack
Command to Run on the
OAK Stack
Update an existing network
configuration.
odacli update-network
Not Applicable
Delete a network.
odacli delete-network
Not Applicable
Configure the network after
either replacing a network
card or swapping the public
network from copper to fiber
and vice versa.
odacli configure-
network
oakcli configure
network
Configure any unconfigured
public networks in bare metal,
Domain 0, and ODA_BASE.
Not Applicable
oakcli configure
additionalnet
Use after replacing InfiniBand
10GbE SFP+ cards (fiber)
cards and before deployment
to unconfigure IB setup and
configure fiber cards.
Not Applicable
oakcli configure
ib2fiber
Create a VLAN
odaadmcli create vlan
Not Applicable
Delete a VLAN
odaadmcli delete vlan
Not Applicable
Display details about the
VLAN
odaadmcli show vlan
Not Applicable
Storage Commands
ODACLI and OAKCLI commands for configuring and managing storage.
Task
Command to Run on the
DCS Stack
Command to Run on the
OAK Stack
Check the cable connections
between the system
controllers and the storage
shelf, as well as the cable
connection to the storage
expansion shelf (if one is
installed).
odacli validate-
storagetopology
Not Applicable
Expand storage.
odaadmcli expand
storage
oakcli expand storage
Display the status of a single
disk or of all disks on the
system.
odaadmcli show disk
oakcli show disk
List configured diskgroups or
display a specific Oracle
Automatic Storage
Management (Oracle ASM)
diskgroup configuration.
odaadmcli show
diskgroup
oakcli show diskgroup
Display details of the
controller.
odaadmcli show
controller
oakcli show controller
Display the RAID SYNC
status.
odaadmcli show
raidsyncstatus
oakcli show
raidsyncstatus
Appendix A
Storage Commands
A-5
Summary of Contents for Database Appliance X6-2-HA
Page 15: ...Index xv...
