Oracle B31003-01, User Manual

Page: 59 / 112

Installing Oracle Connect on an IBM OS/390 or z/OS Series Platform
Installing and Configuring OracleAS Adapter for IMS/TM 6-11
GRNAME
for the XCF group name and
OTMANM
for the IMS member name in that
XCF group, as in the following example:
EDIT IMS.PROCLIB(DFSPBIV1) - 01.03
command ===>
000082 AOIS =,
000083 GRNAME=IMSATT01,
000084 OTMA=YES,
000085 MAXPST=
000086 OTMANM=
3.
Start the OTMA Callable Interface (C/I).
Add an entry in the program properties table (PPT) for the OTMA C/I
initialization program as follows:
a.
Edit the
SCHEDxx
member of the SYS1.PARMLIB data set by adding the
following entry:
PPT PGMNAME(DFSYSVI0) /*PROGRAM NAME =DFSYSVI0 */
CANCEL /*PROGRAM CAN BE CANCELED */
KEY(7) /*PROTECT KEY ASSIGNED IS 7 */
SWAP /*PROGRAM IS SWAPPABLE */
NOPRIV /*PROGRAM IS NOT PRIVILEGED */
DSI /*REQUIRES DATA SET INTEGRITY */
PASS /*CANNOT BYPASS PASSWORD PROTECTION */
SYST /*PROGRAM IS A SYSTEM TASK */
AFF(NONE) /*NO CPU AFFINITY */
NOPREF /*NO PREFERRED STORAGE FRAMES */
b.
To make the
SCHEDxx
changes take effect, perform one of the following tasks:
– Re-IPL the system.
– Issue the
SET SCH=
command.
c.
Edit and submit the following JCL procedure to run
DFSYSVI0
:
//OTMAINIT PROC RGN=3000K,SOUT=A,
/PARM1=
//*
//IEFPROC EXEC PGM=DFSYSVI0,
//REGION=&RGN
//*
//STEPLIB DD DISP=SHR,UNIT=SYSDA,
//DSN=IMSVS.RESLIB
//*
//SYSPRINT DD SYSOUT=&SOUT
//SYSUDUMP DD SYSOUT=&SOUT
//*
4.
Run
DFSYSVI0
after the IPL, to initialize the OTMA C/I.
5.
Copy
INSTROOT .LOAD(ATYDBDC)
to an IMS/TM program library, such as
IMS.PGMLIB
.
Setting Up Oracle Connect for Reentrancy
All Oracle Connect load modules are reentrant to enable subtasking. Therefore, move
INSTROOT .LOAD
to the Link Pack Area (LPA).
Where
INSTROOT
is the high-level qualifier where Oracle Connect is installed.