Note:
There is an ESD receptacle in the top left corner in the rear of the Acme
Packet 6300/6350.
ESD Receptacle
Turn the power source off before you remove or install the power supply.
The power supply is a user-replaceable component. If an Acme
Packet 6300/6350 power supply malfunctions, you should remove the
malfunctioning power supply and replace it. The power supply can be
removed from the chassis while still installed in the rack and while the
second power supply is providing system power; replacing a power supply
while a second power supply continues to provide power is called a warm
swap.
Both power supplies used in the Acme Packet 6300/6350 must be the same
type (AC or DC). The power supplies must be populated with two identical
power supplies made by the same vendor. The vendor is identified by the
label on top of the power supply.
Removing a Power Supply
To remove a power supply from the Acme Packet 6300/6350:
1.
Remove the AC or DC power cables from the power supplies.
Figure 6-1 Removing the Power Cords
Chapter 6
Power Supply Removal and Replacement
6-11