Oracle Acme Packet 6100, Hardware Installation Manual

Page: 10 / 114

2 Acme Packet 6100 Hardware Installation Guide
Precautions
• Note the locations of the System Power switch on the Acme Packet 6100
and the location of the emergency power-off switch for the room where the
Acme Packet 6100 is located.
•
If an electrical accident occurs, remove power from the system
immediately by unplugging the chassis.
•
Always disconnect the power from the system when removing a Acme
Packet 6100 from its rack.
•
When disconnecting power:
• Turn the System Power switch to the Stby position.
• Disconnect the circuit breaker at the rack.
• Unplug or unscrew the power cords from the power supplies.
•
Use grounded AC power cords that are plugged into grounded electrical
outlets.
•
Never use extension cords to power a Acme Packet 6100.
• Ensure that the installation facilities have proper grounding systems and
include a grounded rack structure or local grounding bus bar.
• When installing the Acme Packet 6100 in an equipment rack, always make
the ground connection first and disconnect it last upon un installation.
• Use shielded Category 5e or 6, RJ45 cables for all 10/100/1000 Ethernet
connections to protect the Acme Packet 6100 from potential damage.
• To avoid making a complete circuit (which causes electrical shock), use
only one hand when working with powered-on electrical equipment.
• Use caution when using electrically conductive tools around the Acme
Packet 6100.
• Remove jewelry before working on the Acme Packet 6100.
Battery Warning
Caution: RISK OF EXPLOSION IF BATTERY IS REPLACED BY
AN INCORRECT TYPE. DISPOSE OF USED BATTERY
ACCORDING TO THE INSTRUCTIONS.
Caution: Perchlorate Material — Special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate
.
ESD Safety
To protect the Acme Packet 6100 delicate electronic components from damage
from static electricity, always follow the appropriate ESD procedures and wear