3.
When the console indicates shutdown is completed, unplug the AC power cords
from the power supplies on the rear panel of the Acme Packet 4600.
4.
Confirm that the graphic display is dark and all fans are off.
Rebooting, Resetting, and Power Cycling
Reboot
Rebooting the Acme Packet 4600 shuts down the system in an orderly fashion
and then automatically restarts it. The operating system gracefully shuts down as
processes are terminated and the file system is stopped. While the system and its
processes are stopped, all call processing is immediately halted. You may therefore
wish to perform tasks that call for a reboot during off-peak maintenance hours.
Rebooting the Acme Packet 4600 is required every time you upgrade with a new
version of the Acme Packet 4600 software.
Save your configurations before rebooting the Acme Packet 4600. Refer to the
Maintenance and Troubleshooting Guide for a full explanation of this procedure. The
save-config command is used to save the configuration in the example below.
For a full explanation and all options for the reboot command used in the example
below, refer to the ACLI Reference Guide .
To reboot the Acme Packet 4600:
1.
Save any configuration changes you have made in the ACLI while in Superuser
mode by typing save-config <Enter>.
ACMEPACKET# save-config
Save-Config received, processing.
waiting 1200 for request to finish
Request to 'SAVE-CONFIG' has Finished,
Save complete
Currently active and saved configurations do not
match!
To sync & activate, run 'activate-config' or 'reboot
activate'.
ACMEPACKET#
2.
Execute the reboot command at the Superuser prompt by typing reboot and then
pressing <Enter>.
ACMEPACKET# reboot
-----------------------------------------
WARNING: you are about to reboot this SD!
3.
Type Y and then press <Enter> at the confirmation prompt to proceed with the
reboot.
Reboot this SD [y/n]?: y
Chapter 6
Rebooting, Resetting, and Power Cycling
6-2