9.
Using a #2 Phillips head screwdriver, tighten the screws securely into
place.
10.
Torque the screws on the front and back of the rail slide.
11.
Repeat this procedure for the other slide rail.
Installing the Chassis Flanges and Slide Rails
In this second portion of system installation, two chassis flanges and two chassis slide
rails are secured to the Acme Packet 4600 chassis.
To install the chassis rail slides on the Acme Packet 4600 chassis:
1.
Locate the following components: #10-32 x 5/16” flat head (black) screws (4),
Front-mounting flanges (2), #6-32 x 5/16” screws (6), #2 Phillips screwdriver,
Chassis slide rails (2)
2.
Line up one chassis flange with the tapped holes. Position the chassis
flange’s spring-loaded thumbscrew toward the front panel of the system.
3.
Insert 2 x #10-32 x 5/16” flat head screws into the flange and chassis, and using
a #2 Phillips screwdriver, tighten the screws to secure the flange to the chassis.
4.
Line up the chassis slide rail with the Acme Packet 4600 side panel.
Position the large marker hole in the slide rail at the front of the
Acme Packet 4600 chassis. The remaining three tapped holes in the
Acme Packet 4600 chassis will line up with the slide rail holes.
5.
Use 3 x #6-32 x 5/16” screws to secure the chassis slide rail to the side of the
Acme Packet 4600. Notice that the large hole in the slide is positioned toward the
front of the Acme Packet 4600 chassis.
6.
Repeat this procedure for the other side of the Acme Packet 4600 chassis.
Chapter 4
Cabinet-style 4-Post Chassis Installation
4-9