conditions or to the alarm display during an alarm condition.
Interface Menu
The INTERFACE menu allows you to scroll through a list of all configured physical
interfaces, including the management and media physical interfaces and the loopback
interface.
The following information is displayed for each configured interface to which you scroll:
•
Interface slot and port: interface status
•
Input packets, output packets
•
Input error packets, output error packets: Slot 1: Port0 UP PKT IN: 1,001K OUT:
223K ERR IN: 0 OUT: 0
To use the INTERFACE menu in the graphic display:
1.
From the top menu of the graphic display, press the Enter button.
2.
Press the Up or Down button to scroll to the INTERFACE selection.
3.
Press the Enter button.
4.
Press the Up or Down button to scroll through the list of configured physical
interfaces.
5.
Press the Enter button to refresh the display.
6.
Press the Up or Down button to scroll to the RETURN selection.
7.
Press the Enter button to return to the Top Menu.
BOOT PARAMS Menu
The BOOT PARAMS menu allows you to view the same information configured in
the bootparam ACLI configuration. The BOOT PARAMS selection displays the IP
information necessary to connect to the Mgmt 0 Ethernet interface, located on the
rear of the Acme Packet 4600. This interface is used primarily for maintenance,
configuration, and downloading software images.
The following information for Mgmt 0 is displayed under the BOOT PARAMS menu:
Chapter 3
Graphic Display Menus
3-3