Oracle Acme Packet 4500, Hardware Installation And Maintenance Manual

Page: 25 / 114

COMPONENT OVERVIEW
Acme Packet 4500 Hardware Installation and Maintenance Guide 19
Network
Management Ports
The Acme Packet 4500 has three 10/100/1000 Base-T Ethernet ports located on the
NIU. These ports are used for EMS control, RADIUS accounting, CLI management,
SNMP queries and traps, and other management functions. Refer to the following
image of the Acme Packet 4500’s NIU to see the location of these Ethernet ports.
Figure 2 - 22. Ethernet Ports
Ethernet LED
Each Ethernet jack has two integrated LEDs: one to indicate Link, and one to
indicate Activity. The LED pair is located directly above its associated port.
Figure 2 - 23. Ethernet LEDs (LNK at left and ACT at right)
Link LED The link LED is located to the top left side of the Ethernet port. This LED illuminates
orange when link has been established between the link partner device and the SBC.
Activity LED The activity LED is located to the top right side of the Ethernet port. It illuminates
green when an Ethernet connection has either transmit or receive packet activity.
Upon initial bootup, these Ethernet ports are not configured. You must first connect
to the Acme Packet 4500 over a serial connection before you can configure the
management Ethernet ports for use. You set up the management interfaces using
7 Ground
8 Ground
Table 2 - 3. Alarm Port Pin-Outs
Pin Number Signal Name/Description