Oracle Acme Packet 4500, Hardware Installation And Maintenance Manual

Page: 105 / 114

SPECIFICATIONS
Acme Packet 4500 Hardware Installation and Maintenance Guide 99
Alarm Port Dry
Contact Current
Limits
This table lists the Acme Packet 4500’s alarm port’s electrical characteristics.
Table 7 - 23. Alarm Port Dry Contact Current Limits
Specification Value
Max AC switching current 0.3 A @ 125 VAC
Max DC switching current 1 A @ 30 VDC
Environmental Specifications
For the Acme Packet 4500 to function properly, we recommend that you follow the
environmental guidelines in the following table.
Table 7 - 24. Environmental Specifications
Specification Description
Temperature The Acme Packet 4500 is required to operate within the
temperature range of:
+0° C to +40° C, 32° F to 104° F (operating)
-20° C to +65° C, -4° F to 149° F (storage)
Relative Humidity Operating conditions of 10% to 85% humidity under non-
condensing operating conditions
Maximum Altitude The Acme Packet 4500 is required to operate below the
maximum altitude of 10,000 feet.
Air Flow 50 CFM
Heat Dissipation 100W (341 BTU/hr) typical, 200W (682 BTU/hr) maximum
Connector Specifications
Refer to the following table for information about the connector specifications for the
Acme Packet 4500.
Table 7 - 25. Connector Specifications
Specification Description
RJ45/Management Ethernet
Ports The 3 x 8-pin RJ45 10/100/1000BaseT Gigabit Ethernet ports
are compliant with IEEE's 802.3, 802.3u, and 802.3ab.
RJ45/Alarm Contact Port Any alarms generated by the system are accessible via the 8-pin
RJ45 alarm contact port.
RS232/Serial Port The RS232 serial port uses an 8-pin RJ45 connector that
supports RS232-C protocol.
GbE Port(s) The GbE fiber optic connection ports use duplex LC connectors.