INT Ethernet LNK/ACT LEDs
The INT LNK LED and ACT LED indicate the respective link and activity over the INT
Ethernet port on the rear of the chassis. See the section on Network Management Ports for
further information on the meaning and use of these LEDs as they pertain to the INT port.
NET MGT Ethernet LNK/ACT LEDs
The NET MGT LNK LED and ACT LED indicate the respective link and activity over the
NET MGT Ethernet port on the rear of the chassis. See the section on Network Management
Ports for further information on the meaning and use of these LEDs as they pertain to the NET
MGT port.
USB Port
The USB port is reserved for software-enabled applications such as firmware and system
upgrades and for remote access by customer service representatives. The USB port is for Acme
Packet use only and is not to be used by the customer unless directed by a customer service
representative.
Rear Panel
Network management and other ports are located on the rear of the chassis.
Figure 2-3 Acme Packet 1100 Rear Panel
Power Connector
12V of DC power is supplied to the 12V DC power connector via an external AC power
supply. (Options are available for providing a country-specific AC cable.)
Reset Button
A hard reset of the Acme Packet 1100 can be performed by pressing the reset button. This
button is recessed and can only be pressed by inserting a thin wire (e.g., a paper clip) through
the reset button channel. Pressing the reset button can result in the loss of software data or your
configuration.
Chapter 2
System Control Panels
2-3
