Optoma ZU850, User Manual

Page: 42 / 69

English 42
USING THE PROJECTOR
Communications menu
DISPLAY
OUTPUT
SETUP
OPTION
Communications
19200
RS232
0
LAN
WLAN
Network
Serial Port Baud Rate
Serial Port Path
Projector Address
LAN
Configure the local area network (LAN) settings.
‡ DHCP : Turn the DHCP ON/OFF.
‡ IP Address : Select an IP address.
‡ Subnet Mask : Select subnet mask number.
‡ Gateway : Select the default gateway of the network connected to the projector.
‡ MAC Address : Display the network MAC Address value.
‡ Apply : Apply Network settings.
WLAN
Configure the wireless local area network (WLAN) settings.
‡ Enable : Enable/Disable WLAN.
‡ Start IP : Start of IP Address.
‡ End IP : End of IP Address.
‡ Subnet Mask : Assign Network Subnet Mask.
‡ Gateway : Assign Network Default Gateway.
‡ MAC Address : Display network MAC Address value.
‡ SSID : Assign Network Service Set Identifier.
Network
Configure the general network settings.
‡ Projector Name : Display the projector hostname for Network.
‡ Restart Network : Restart the network.
‡ Network Factory Reset : Perform factory reset on the network settings. The Projector Name, LAN IP,
WLAN IP, and SNMP settings will be reset
Serial Port Baud Rate
Select the serial port its baud rate.
Serial Port Path
Select the serial port path from either RS232 or HDBaseT.
Projector Address
Set the projector address. The projector will respond to IR remotes set either at the same address as the projector
or to IR remotes set to address 0.