Optoma EH200st, User Manual

Page: 81 / 89

80
Appendices
Command Description Remark (Parameter)
Config-URL Device’s IP address
LAN IP address is shown up if
LAN IP address is valid.
Wireless LAN IP address is
shown up if Wireless LAN IP
address is valid.
http://xxx.xxx.xxx.
xxx/index.html
Revision The revision must follow a major.
minor.micro scheme. The revision
is only increased if the command
protocol is modified.
1.0.0
• For wide screen resolution (WXGA), the compatibility support is
dependent on Notebook/PC models.
• This AMX function is only to support AMX Device Discovery.
• The broadcast information only send out through valid interface.
• Both LAN and Wireless LAN interfaces could be supported at the same
time.
• If “Beacon Validator” was used. Please take care below information.
PJLink™ supported commands
The table below shows commands to control the projector using
the PJLink™ protocol.
Command Description Remark (Parameter)
Command Description Remark (Parameter)
POWR Power control
0 = Standby
1 = Power on
POWR? Inquiry about the
power state
0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
INPT INPT Input switching
11 = VGA1
N
ote
N
ote