English
30
USING THE PROJECTOR
Powering off
1.
Turn off the projector by pressing the power button “ ” on the projector keypad or the
OFF
button “ ”
on the remote control.
A message will pop up to confirm that you want to turn off the projector.
2.
Press the power button or the
OFF
button again to confirm, otherwise the warning message
disappears after 10 seconds and the projector remains on.
3.
Set the Power switch to the “
o
” (OFF) position.
The status LED turns from blinking orange to solid orange and the keypad also turns to solid orange.
4.
Disconnect the power cord from both the projector and the electrical outlet.
Note:
It is not recommended to turn on the projector immediately after powering it off. Wait for 10 seconds until
you power it on again.
Selecting an input source
Turn on the connected source that you want to display on the screen, such as computer, notebook, and/or video
player. The projector will automatically detect the input source. If multiple sources are connected, press the
Input
button on the remote control or
Input
key on the projector keypad to select an input source.
REMOTE IN
REMOTE OUT
IN
PU
T
or
IN
PU
T
Summary of Contents for DLP ZU1700
Page 1: ...DLP Projector...
Page 12: ...English 12 INTRODUCTION Bottom view 1 No Item 1 Security bar...
Page 120: ...www optoma com...
