Optoma 3600ANSI, User Manual

Page: 52 / 73

English 52
USING THE PROJECTOR
1. Select Start > All Programs .> Accessories > Command Prompt .
2. Input the command format as follows:
± telnet ttt.xxx.yyy.zzz 23 (“Enter” key pressed)
± (ttt.xxx.yyy.zzz: IP-Address of the projector)
3. If Telnet-Connection ready, and user can have RS232 command input, then “Enter” key pressed, the
RS232 command will be workable.
Specification for “RS232 by TELNET” :
1. Telnet: TCP.
2. Telnet port: 23 (for more detail, kindly please get contact with the service agent or team).
3. Telnet utility: Windows “TELNET.exe” (console mode).
4. Disconnection for RS232-by-Telnet control normally: Close
5. Windows Telnet utility directly after TELNET connection ready.
± Limitation 1 for Telnet-Control: there is less than 50 bytes for successive network payload for
Telnet-Control application.
± Limitation 2 for Telnet-Control: there is less than 26 bytes for one complete RS232 command for
Telnet-Control.
± Limitation 3 for Telnet-Control: Minimum delay for next RS232 command must be more than 200 (ms).
Info menu
Info menu
View the projector information as listed below:
‡ Regulatory
‡ Serial Number
‡ Source
‡ Resolution
‡ Refresh Rate
‡ Display Mode
‡ Power Mode (Standby)
‡ Lamp Hours
‡ Network Status (Type 2 only)
‡ IP Address
‡ Projector ID
‡ Filter Usage Hours
‡ Brightness Mode
‡ FW Version