User Manual – eSX
OptiPro Systems, LLC.
Page 108 of 111
Last Modified: 8/27/2014
10.2
Manual Commands
Warning: Any manual data commands can cause machine collisions. Do not perform them unless
properly trained to do so.
Warning: Always set the
Feed Rate Override
knob on the control panel to
0%
before pressing the
CYCLE
START
button for a manual command!
Warning:
Feed Rate Override
knob does not control spindle speeds!
10.2.1
M Code List
LIST MAY VARY DEPENDING ON MACHINE MODEL
M Code
Description
0
Feedhold Program STOP
1
Feedhold Conditional Program STOP
3
Work Spindle(S2) clockwise rotation; Left Tool Spindle(S1) clockwise rotation
4
Work Spindle(S2) counterclockwise rotation; Right Tool Spindle(S1) clockwise rotation
5
Stop spindle rotation (M5.S1, M5.S2)
6
Perform Tool Change (T5M6, T1-8)
7
Turn on Thru the Tool Spindle Coolant
8
Turn on coolant
9
Turn off coolant
10
C-Axis Break On
11
C-Axis Break Off
12
Initiate lube cycle
15
C-Axis Position Mode Disable, Work Spindle Mode Enabled
16
C-Axis Position Mode Enable
18
Perform reset for C-Axis Position Control
20
C-Axis Vacuum Enable
21
C-Axis Vacuum Disable
26
C-Axis Vacuum Monitoring Enable
27
C-Axis Vacuum Monitoring Disable
29
End of Spindle/Axis Switch Command
30
End program, Stop Spindles
31
Reference Program Complete
35
Enable Tool RFID Cycle
36
Trip Tool RFID Cycle
38
Orient Tool Spindle Disable
39
Orient Tool Spindle Enable
50
Laser Probe Enable
51
Laser Probe Disable
54
CTS Flow Monitoring Enable
