Optimum OPTIturn TX 6222, Operating Manual

Page: 11 / 124

Safety
Version 1.0.1 dated 2017-11-16 Page 11 Translation of the original instructions
TX6222 GB
T
X
6222
_GB
_1.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to personnel,

there is a risk of damage to the lathe and other property,

the correct function of the lathe may be affected.
Always disconnect the lathe, when cleaning or maintenance work is being carried out.
WARNING!
The lathe may only be used with the safety devices activated. Disconnect the lathe
immediately whenever you detect a failure in the safety devices or when they are not
mounted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices. As the operating company, this is your responsibility!

"Safety devices“ on page 14
1.6 Qualification of personnel
1.6.1 Target group
This manual is addressed to

the operating companies,

the operators,

the maintenance personnel.
Therefore, the warning notes refer to both the operation and maintenance of the lathe.
Determine and indicate clearly who will be responsible for the different activities on the lathe
(operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
Always disconnect the main plug of the lathe and secure the main switch using a lock. This will
prevent it from being used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator has been instructed by the operating company regarding the assigned tasks and
possible risks in case of improper behaviour. Any tasks which need to be performed beyond the
operation in standard mode must only be performed by the operator, if so indicated in these
instructions and if the operator has been expressively commissioned by the operating com-
pany.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.