OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.1 dated 2018-01-31
Page 12
Translation of the original instructions
TM4010 | TM4010D
GB
T
M
4010_
T
M
4010D_G
B_1
.f
m
may only be performed by an operator if they are described in these instructions and if the oper-
ator has been specifically trained to perform them by the operating company.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.
Qualified personnel
Due to their professional training, knowledge and experience as well as knowledge of relevant
regulations, qualified personnel are able to perform the assigned tasks and to independently
recognise and avoid any possible dangers.
Instructed person
Instructed persons were instructed by the operating company regarding the assigned tasks and
any possible risks of improper behaviour.
1.6.2
Authorized persons
WARNING!
Inappropriate operation and maintenance of the lathe constitutes a danger for the
personnel, objects and the environment.
Only authorized personnel may operate the lathe!
Persons authorized to operate and maintain should be trained technical personnel and
instructed by the ones who are working for the operating company and for the manufacturer.
1.6.3
Obligations of the operating company
The operator must instruct the personnel at least once a year regarding
all safety standards that apply to the lathe.
the operation,
generally accepted engineering standards.
The operator must also
check the personnel‘s knowledge level,
document the training/instruction,
have attendance at the training/instruction confirmed by signature and
check whether personnel is working in a manner that shows awareness of safety and risks.
Define and document the machine inspection deadlines in accordance with section 3 of the
Factory Safety Order and perform an operational risk analysis in accordance with section 6
of the Safety at Work Act.
1.6.4
User's obligations
The operator must
have read and understood the operating manual,
be familiar with all safety devices and regulations,
be able to operate the lathe.
1.6.5
Additional requirements regarding the qualification
Additional requirements apply for work on electrical components or equipment:
