Optimum Optimum 3292385, Operating Instructions Manual, Page: 8 / 80

Safety
Version 1.0.4 - 2020-10-13 8 Translation of original instruction
SD500AV
EN
SD500A
V_G
B
_1.
fm
INFORMATION
The metal band saw with frequency converter is built according to the standard EN61800 class
C2.
WARNING!
Class C2 (machine tools) is not intended for use in residential or mixed areas where the
power supply is provided by a low-voltage public power supply system. In these areas it
may possibly be difficult to guarantee electromagnetic compatibility due to lead bound
as well as emitted interferences.
Overview of EMC categories:
Categorie C1

required limit values Class B Group 1 according to EN 55011
Categorie C2

Required limit values class A Group 1 according to EN 55011, Installation by EMC
expertsand warning: “This is a product of category C2 according to EN 61800-3. This pro-
duct may cause radio interference in a residential area. In this case, it may be necessary for
the operator to take appropriate action.“
Categorie C3

Required limit values class A group 2 according to EN 55011, whereby these limit values
are below those of class A group 1, plus warning: „This type is not suitable for connection to
a public low-voltage network supplying residential buildings. When connecting to a public
low voltage network, radio frequency interference is expected. "
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
metal belt saw! They could endanger people and cause damage to the metal belt saw.
1.5 Reasonably foreseeable misuses
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning. Operators must be qualified.
1.5.1 Avoiding misuse

Use the correct metal saw bands, tooth pitch, depending on the material to be sawed.

Correct belt speed and feed depending on the material to be sawed.
This machine
Categorie C1 C2 C3 C4
Environment
Residential area
Business area
Industrial area
Industry
Voltage / Current < 1000 V > 1000 V
EMC knowledge no requirement Installation and commissioning by an EMC expert