Optimum Optimum 3292385, Operating Instructions Manual, Page: 73 / 80

Appendix
Version 1.0.4 - 2020-10-13 73 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_9.
fm
8 Appendix
8.1 Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2 Terminology/Glossary
8.3 Change information manual
Term Explanation
Workpiece • Material to be cut
Blade guide pulley
Saw band roller
Blade pulley
• Pulley through which the saw blade passes in the saw arch
Saw bow • Housing with protective cover for the saw blade
Material stop • Position for multiple cuts
• Sawing stop
Hydraulic cylinder • Hydraulic lowering cylinder
• Hydraulic feed
Feed control valve • Valve for adjusting the lowering speed
Protective cover saw arch • Cover on the saw arch
Blade guide bearings • Rollers between which the saw blade passes
• Pilot bearing
Saw band guide • Blade guide bearings
Saw blade brush • Device for scraping off impurities
• Saw blade cleaning brush
Clamping jaw • Strip terminal on the machine vice
Machine vice • Clamping device for the workpiece
Gear • Reduction gear from drive motor to the belt guidance rollers
Cutting speed • Speed of the saw blade
Drive motor • Engine
Chapter Short note new version no.
3.4.1 + 6 Running-in process 1.0.1
2 ; 3 Net interdepartmental transport 1.0.2
2 + parts 3kW drive motor + 3kW gear + 3kW Siemens inverter 1.0.3
4.2.2 Danger, hydraulic vice 1.0.4