Optimum Optimum 3292385, Operating Instructions Manual, Page: 34 / 80

Operation
Version 1.0.4 - 2020-10-13 34 Translation of original instruction
SD500AV
EN
SD500A
V_G
B
_4.
fm
4.5 Resetting an emergency stop situation

Lift the saw bow and close the lowering valve.

Unlock the emergency stop button again.

Switch on the control with the rotary switch (13).
4.6 Power failure, Restoring readiness for operation

Lift the saw bow and close the lowering valve.

Unlock the emergency stop button again.

Switch on the control with the rotary switch (13).
4.7 Turn the saw bow
ATTENTION!
Check your setting before each sawing operation. The saw band guide must not touch
the machine vice.

Move the clamping lever to the left to release the clamping of the saw bow.

Turn the saw arch to the required cutting position. The scale which you need to adjust the
angle is on the bearing support.

Secure the setting by re-clamping the saw bow with the clamping lever.
For saw cuts in the range from 0° to 60° the machine stop can be used.
For saw cuts ranging from 0° to -45° the workpiece stop needs to be disassembled. For this
purpose, also slide the vice into the left position.
60
°
45°
-