Optimum Optimum 3292385, Operating Instructions Manual, Page: 25 / 80

Version 1.0.4 - 2020-10-13 25 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_3.
fm
3.2.9 Fill with coolant
ATTENTION!
Destruction of the pump due dry running. The pump is lubricated by the coolant. Do not
operate the pump without coolant.
The capacity of the tank is approx. 36 litres of coolant.
3.2.10 Checks
Perform the following checks.
ATTENTION!
Danger of cutting, perform the works described hereunder with care. Use the prescribed
protective equipment.
Direction of the saw teeth

Control the direction of the saw teeth. The saw teeth
have to point to the drive engine.
Running direction of the saw band

The running direction of the saw band is counter-clock-
wise.
Control the saw band pulleys

Check if the saw band is mounted correctly onto
the saw band pulleys. The saw band has to be in
contact to the recess of each pulley.
Fig.3-8: Saw band pulleys
Checking the oil pressure on the hydraulic unit

Check whether the operating pressure is set on the pressure gauge of the hydraulic unit.

„setting the operating pressure“ auf Seite 47
Running direction of the motor on the hydraulic unit

The running direction of the motor is clockwise
(viewed from the fan side).
Fig.3-9: Motor running direction
Drive motor