Optimum Optimum 3292385, Operating Instructions Manual, Page: 20 / 80

Version 1.0.4 - 2020-10-13 20 Translation of original instruction
SD500AV
EN
SD500A
V_G
B
_3.
fm
3.1.2 Load suspension point

Fasten the load end material on the assigned load end positions on the machine sub-
structure.

Use an adequate conveyor equipment, for instance a crane.

Make sure that you distribute the loads evenly so that the metal belt saw cannot turn over
while lifting.

Make sure that no add-on pieces or varnished parts are damaged due to the load suspen-
sion.
Fig.3-1: Load end, center of gravity
3.2 Set-up and assembly
3.2.1 Scope of delivery
INFORMATION
The metal belt saw is delivered pre-assembled.
When the metal belt saw is delivered, please check immediately that it has not been damaged
during transport. Also check that no fastening screws have come loose.
3.2.2 Requirements regarding the installation site
Organize the working area around the metal band saw according to the local safety regulations.
INFORMATION
In order to achieve high levels of functionality and machining accuracy, as well as a long ser-
vice life of the machine, the set-up location should meet certain criteria.
The following points should be noted:

The device must only be installed and operated in a dry and well-ventilated place.
4x
DIN 580-M16