Optimum Optimum 3292385, Operating Instructions Manual, Page: 16 / 80

Safety
Version 1.0.4 - 2020-10-13 16 Translation of original instruction
SD500AV
EN
SD500A
V_G
B
_1.
fm
The inspection prior to initial commissioning is not required if the operator receives confirma-
tion from the manufacturer or installer that the electrical systems and operating equipment com-
ply with the accident prevention regulations, see conformity declaration.
Permanently installed electrical systems and operating equipment are considered constantly
monitored if they are continually serviced by qualified electricians and inspected by means of
measurements in the scope of operation (e.g. monitoring the insulation resistance).
1.16 Hydraulic system
The system is under a pressure of up to 280 bar.
WARNING!
Serious injuries from hydraulic liquid escaping under high pressure!
Possible loss of the eyesight!
Make sure the hydraulic system is depressurized before opening any component or line. Wear
safety goggles and protective clothing when carrying out any work on the hydraulic system.
Even after switching off the central power supply at the machine, the hydraulic system can still
be under stored pressure.
If hydraulic liquid squirts into your eyes, immediately rinse it with plenty of water. Immediately
seek medical assistance.
1.17 Inspection deadlines
Define and document the inspection deadlines for the machine in accordance with § 3 of the
Factory Safety Act and perform an operational risk analysis in accordance with § 6 of the Work
Safety Act. Also use the inspection intervals in the maintenance section as reference values.