Operation
Version 1.0.4 - 2020-09-08
47
Translation of original instructions
MZ2S
EN
MZ
2S
_G
B_4.
fm
4.18.1 Horizontal milling with counter-bearing
CAUTION!
Always mount counter-bearing if machining with a side milling cutter and set the gear
switch of vertical spindle to "0".
Rotate the vertical milling head 90 ° and firmly clamp the clamping lever of the quill.
Rotate milling head vertically on page 43
Loosen the clamping levers ( 2 ) for the carriage on the milling head and move the carriage
of the milling head with a key ( 3 ) completely forwardly.
Dismantle the protective cover ( 4 ) of the horizontal spindle.
Set the arbor (5) in the spindle, attach the counter-bearing ( 6 ), tighten the drawbar ( 7 ),
tighten the clamping screw ( 8 ) on counter-bearing.
Put the gear switch for vertical milling to position "0".
Vertical spindle gearbox switch on
2
3
4
5
6
8
7
