Version 1.2.8 - 2020-08-03
37
Translation of original operating manual
MT50
GB
MT
5
0_GB
_4.
fm
The milling head may be swivelled to the right and to the left.
Release the two nuts in order to clamp the rotary disc.
Turn the square box spanner in order to slew the milling head. Use the scale at the turnta-
ble to set the angle.
Clamp the nuts again after adjusting the required angle.
Img.5-9: Swivelling the milling head
5.9.1
Set milling head to the zero position
Loosen the two nuts to clamp the turntable.
Turn the hexagon until the milling head is in the zero position.
ATTENTION!
For a high precise alignment in zero position we recommend you to use a control man-
drel which is directly clamped in the spindle and is lower using a gauge.
Clamp the nuts again.
5.10
Raising / lowering the cross table
Manual movement on the Z axis
You can raise or lower the cross table using the crank handle.
Loosen the tightening lever.
Engage the crank handle by pushing it towards the clutch.
Turn the handle to the required position for the cross table.
Clamping nut (2x)
Turntable including scale
Square
