Optimum OPTimill F 150, Operating Manual

Page: 11 / 162

OPTIMUM
M A S C H I N E N - G E R M A N Y
Safety
Version 1.1.6 dated 2014-10-16 Page 11 Original operating instructions
F150 GB
1.5 Possible dangers caused by the CNC machine
The CNC machine has undergone a safety inspection.. The construction and type are state of
the art.
Nevertheless, there is a residual risk as the CNC machineoperates with

rotating parts,

electrical voltage and currents,

compressed air,

rapid moves.
We have used construction resources and safety techniques to minimize the health risk to per-
sonnel resulting from these hazards.
If the CNCmachine is used and maintained by the personnel who are not duly qualified, there
may be a risk resulting from incorrect or unsuitable maintenance of the CNCmachine.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

strictly follow these operating instructions.
In the event of improper use

there may be a risk to the personnel,

there may be a risk to the CNC machine and other material values,

the correct function of the CNC machine may be affected.
Always switch off the CNC-machine and disconnect it from the mains if you perform cleaning or
maintenance works.
WARNING!
The CNC machine may only be used with the safety devices activated. Disconnect the
CNC-machine immediately, whenever you detect a failure in the safety devices or when
they are not fitted!
All additional parts of the machine which had been added by the customer need to be
equipped with the prescribed safety devices.
This is your responsibility being the operating company!

"Safety devices“ on page
13
1.6 Qualification of personnel
1.6.1 Target group
This manual is addressed to

the operating companies,

operators having sufficient specialist knowledge,

the maintenance personnel.
Therefore, the warning notes refer to both operation and maintenance of the CNC machine.
Determine clearly and explicitly who will be responsible for the different activities on the CNC-
machine (operation, setting up, maintenance and repair). Please note the name of the responsi-
ble person into an operators´s log.
INFORMATION
Unclear responsibilities constitute a safety risk!
Always lock the main switch after switching off the CNC-machine. This will prevent it from being
used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below: