OPTIMUM
M A S C H I N E N - G E R M A N Y
Delivery, interdepartmental transport, unpacking
Version 1.0 dated 2017-03-13
Page 26
Original operating instructions
RD4
GB
R
D
4_
GB
_3.
fm
2.8
Coolant tank
Fill in the tank with a suitable coolant. Fill it up to a maximum of the centre of the slotted screen.
"Operating material“ on page 49
Img.2-4:
Coolant tank in the machine foot
2.8.1 One-component paint
The radial drilling machine is lacquered with a one-component paint. Observe this fact when
selecting your cooling lubricant and cleaning of the radial drilling machine.
A one-component lacquer with solvent part hardens when the solvent evaporates.
As soon as the lacquer is applied the solvent evaporates into the air. The binder becomes
felted and a dry film is formed. This process is reversible, i.e. the binder can be etched again
and again.
A two-component paint also consists of binding agent and solvent. However, the paint only
dries when a setting agent is added. This process is not reversible, i.e. the binding agent can-
not be re-softened.
The company Optimum Maschinen Germany GmbH does not assume any guarantee for sub-
sequent damages due to unsuitable cooling lubricants.
2.9
Transport locking devices
Remove transport locks.
Remove beam to support the cantilever.
2.10
Cleaning and lubrication
Remove the anti-corrosive agents on the radial drilling machine which had been applied for
transportation and storage. We recommend you use paraffin for this purpose.
Do not use any solvents, thinner or other cleaning agents which could corrode the varnish
on the radial drilling machine. Observe the cleaning agent manufacturer's information and
notes.
Grease all exposed machine parts using an acid-free lubricating oil.
Lubricate the radial drilling machine according to the lubricating plan.
Check if all spindles are running smoothly.
Filler hole
Slotted screen
