10
1. Power plug
2. Cord reeling pedal
3. Cyclone dust barrel
4. Dirt container release button
5. Hose
6. Accessory bracket
7. Handle
8. Air escape pushbutton
9. Metal telescopic tube
10. Switch Pedal
11. Air outlet grid
12. Ordinary floor brush
Accessories:
1. Flat nozzle
2. Combination brush
1. Before assembling the cleaner, please confirm all parts
and components for the cleaner are received by referring
to Parts and Components List.
2. Please remember to cut off the power supply before
assembly.
Assembly of hose
As is shown in Figure (3), insert the hose into the duct inlet
of the machine body in horizontal direction. Please pay
attention to the alignment of two projecting parts. Turn the
hose right when it is pushed into the bottom, a click of
inserting sound may be heard, i.e. the hose is assembled
into the machine body completely.
Assembly and Removal of dust barrel
As is shown in Figure (4), place the bottom of the dust
barrel on the projecting part at the front end of the machine
body, and press down the dust barrel. When the front-end
hook is entered into the corresponding part of the machine
body completely, and a click of inserting sound is heard,
which indicate that the dust barrel is assembled in place.
To remove the dirt container, press the dirt container
release button and lift the dust container up and out of the
appliance using the handle.
Assembly of accessories
1. Figure (5) is the accessory bracket. Get the flat nozzle
and the combination brush stuck in the corresponding
clips according to the accessory installation indication
shown on the accessory bracket.
Assembly of metal extension pipe and floor brush
Insert the front end of the hose handle into the metal exten-
sion pipe according to Figure (6); then insert the other end
of the metal extension pipe into the rounded inlet of the
floor brush, and adjust to the proper direction. At this time,
the assembly of the whole machine is completed.
How to start
1. First of all, pull out the power cord from the cord reel to
the needed length; insert the power cord plug into the
power socket, and press down the power switch button
with finger or step on it with foot; then you can control the
start and stop of the cleaner.
2. The yellow mark on the power cord indicates its desired
length. Never pull out the power cord to the length
exceeding the red mark.
Control of suction force
When the suction inlet is jammed by some cloth due to the
over-large suction force, you can adjust the air escape push-
button on the hose handle to control the suction force at the
suction inlet, as is shown in Figure (7).
Figure (3)
Figure (4)
Figure (5)
Figure (6)
OK4140_ver200.qxp 2007-11-28 11:18 Page 10 (Black plate)
