Optimum HNC-2000, Operating Instructions Manual

Page: 10 / 34

10
2 buttons for setting heat in 1 of 3 ranges:
“I” - 750 W
“II” - 1,250 W
“I”+ “II” – 2,000 W (750+1,250)
Then turn the thermostat knob towards max. position, which
will make the heater start (if the thermostat knob remains
at “min.” position, the convection heater will not start
operating). With the thermostat knob you can adjust the
automatic operation of the convection heater - by setting
a specific level of the room temperature. At the moment
the room temperature reaches the set level (set on the
thermostat), the device will turn off; if the temperature in
the room drops below the set level, the convection heater
will turn on again. Additionally the convection heater has
an internal fan (switched by a separate button) to assist in
spreading hot air - turbo function.
Automatic power-off protection
If overheating, it will power off automatically, protect the
heater, use safely.
CLEANING AND MAINTENANCE
The convection heater should be kept clean. Before cleaning
or any other maintenance work it is essential to disconnect
the device from the power source (in accordance with the
safety rules, including unplugging the device) and wait
until the heater cools down. Use only a soft, damp cloth for
cleaning. Do not use abrasive cloths or sponges, as they can
scratch the surface. Never use detergents or other chemicals
to clean the device. Do not allow electrical parts (including
switches, plugs, heating elements) to come into contact with
water.
Take proper care of the equipment to maintain the warranty.
ASSEMBLY
• Remove the packing and make sure that the appliance is
intact.
• Place the appliance upside down.
• Fix the feet with screws. After assembling, make it
upstanding.
750 W
2000 W
1250 W
Turbo ventilation
ON/OFF
Heating
Convection heater with Turbo ventilation
Max.
temperature Min. temperature
Thermostat knob
750 W
2000 W
1250 W
Heating
Convection heater without Turbo ventilation