OPTIMUM
M A S C H I N E N - G E R M A N Y
General warning notes
29 / 11 / 2006
Page
3
General warning notes CNC Controller III and VI ; Version 2.0.1
©
2006
GB
1
General warning notes
Glossary of symbols
This part of the operation manual
explains the meaning and use of the warning references contained in the operation manual,
explains how to use the CNC Controller properly,
highlights the dangers that might arise for you or others if these instructions are not obeyed,
tells you how to avoid dangers.
In addition to this operating manual please observe
applicable laws and regulations,
legal regulations for accident prevention,
the warning notes on the CNC Controller.
ALWAYS KEEP THIS DOCUMENTATION CLOSE TO THE CNC CONTROLLER.
1.1
Proper use
The CNC Controller is designed and built to be used in dry and non-explosive environments. It is
provided to control step motors up to a maximum power of 6A at 40 V.
It is also part of proper use that
the maximum values for the CNC Controller are to be complied with,
the operating manual needs to be observed.
WARNING!
It is Forbidden to make any modifications or alterations to the values of the CNC
Controller!
These could endanger the staff and cause damages to the CNC Controller and the
connected devices.
WARNING!
•
Always disconnect the CNC Controller when exchanging the control board.
•
Wait at least 3 minutes until you open the housing of the CNC Controller.
•
Switch off the CNC Controller with the main switch, if the CNC Controller is not in use.
gives additional indications
calls on you to act
enumerations
