OPTIMUM
M A S C H I N E N - G E R M A N Y
Safety
Version 2.2.2 dated 2014-03-07
Page 13
Original operating instructions
B24H | B24HV | B28H | B28HV
GB
being expelled, but not to remove them completely. Always work carefully and observe
the limit values of your chipping process.
The drilling machine machine includes the following safety devices:
an EMERGENCY STOP push button,
a drilling table with T-slots to fix the workpiece or a vice,
a protective cover for the pulleys with positioning switch,
a drill chuck guard, in order to prevent interference with the rotating tool.
1.9
Safety check
Check the drilling machine before each start-up or at least once per shift. Inform the person
responsible immediately of any damage, defect or change in operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation),
after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the driling machine.
are legible (clean them, if necessary),
are complete (replace if necessary).
INFORMATION
Use the following table in order to organize the checks.
General check
Equipment
Check
OK
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markings
Installed and legible
Date:
checked by (signature):
Functional check
Equipment
Check
OK
EMERGENCY-STOP
Push button
After actuating an EMERGENCY STOP push button the drilling
machine must be switched off.
Limit switch protective
cover
V-belt
The drilling machine must not be switched on, if the protective
cover of the V-belts is opened. An opening of the protective
cover during machine operating turns off the machine.
Drill chuck protection
The drilling machine must only be switched on, if the drill chuck
protection is closed. The engine must switch off when the drill
chuck protection is opened during operation.
Date:
checked by (signature):
