Safety
Version 1.0.2 - 2020-07-20
9
Translation of original instruction
TM3310 | TM3310D
EN
T
M
3310_
GB_1
.f
m
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH.
It is also part of the intended use that you
observe the limits of the lathe,
observe the operating instructions,
and comply with the inspection and maintenance instructions.
Technical specification on page 16
In order to achieve optimum cutting performance, it is essential to choose the right turning tool,
feed, tool pressure, cutting speed and coolant.
WARNING!
Severe injuries due to non-intended use.
It is forbidden to make any modifications or alternations to the operation values of the
lathe. They could endanger the personnel and cause damage to the lathe.
1.4
Reasonably foreseeable misuses
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
The lathe must not be used to process metal, cold and non-inflammable materials.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before the first commissioning.
The lathe operator must be qualified.
Obligations of the operating company on page 10
1.4.1
Avoiding misuse
Use of suitable cutting tools.
Adapting the speed adjustment and feed to the material and workpiece.
Insert the workpiece tightly, without vibration and without one-sided imbalances.
The machine is not designed for the use of hand tools (e.g. emery cloth or files). It is forbid-
den to use any hand tools on this machine.
The machine is not designed to allow long parts to protrude beyond the spindle hole. If lon-
ger parts have to protrude beyond the spindle hole, an additional operator-side, permanent
device must be mounted, which completely covers the protruding part and provides com-
plete protection against spinning parts.
Long workpieces must be propped up. Use the steady rest or follow rest in conjunction with
the tailstock spindle to support longer parts and prevent the workpiece from flapping around
and flying away.
Risk of fire and explosion due to the use of flammable materials or cooling lubricants.
Before processing inflammable materials (e.g. aluminium, magnesium) or using inflam-
mable auxiliary materials (e.g. spirit), it is necessary to take additional preventive measures
in order to avoid health risks.
When processing carbons, graphite and carbon-fibre-reinforced carbons, the machine is no
longer being used as intended. When processing carbons, graphite and carbon-fibre-rein-
forced carbons and similar materials, the machine can be damaged quickly, even if the
dusts generated are completely sucked out during the work process.
The processing of plastics with the lathe leads to static charge. The static charge of
machine parts from processing plastics cannot be safely conducted away from the lathe.
When using lathe dogs as carriers for rotating workpieces between the lathe centres, the
standard lathe chuck shield must be replaced with a circular lathe chuck shield.
