Maintenance
Version 1.0.2 - 2020-07-20
59
Translation of original instruction
TM3310 | TM3310D
EN
T
M
3310_
GB_5
.f
m
6
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the lathe.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long durability of the lathe and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
Attention!
Never remove chips or clean the working area of the lathe with compressed air. Cleaning
inside the working area using compressed air may cause damages to the lathe.
6.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
Severe injuries of persons working on the lathe,
Damage to the lathe.
Only qualified personnel should carry out maintenance and repair work on the lathe.
6.1.1
Preparation
WARNING!
Only work on the lathe when the mains plug has been pulled out. Attach a warning label.
6.1.2
Restarting
Before restarting, run a safety check.
WARNING!
Before starting the lathe, you must check that there is no danger for persons and that
the lathe is not damaged.
