Optimum 3338165, Operating Manual

Page: 40 / 86

Version 1.1.0 - 2020-08-07 40 Translation of original instruction
MH35G │ MH35V EN
M
H
35
G
_M
H
35
V
_
GB
_
4.
fm
4.14 Swivelling the milling head
The milling head can be swivelled to the right and to the left.

Loosen 3 fastening screws on the milling head.

Turn the drill-mill head clockwise to the desired position.

Retighten the fastening screws.
INFORMATION
The milling head should be aligned after resetting to the initial position with a dial indicator so
that holes can be produced with the spindle sleeve at a right angle. Set the zero degree angle
step using your set-up.
ATTENTION!
The drill-mill continues significantly further and also swivels in a different direction. By
continuing to swivel, gear oil may seep from the ventilation hole.
A
B
Clamping bolts