Version 1.0.4 - 2020-07-28
31
Translation of original instruction
MH22V
│
MH22VD
EN
MH
22
V_MH2
2
VD_G
B_4.
fm
4.11
Inserting or Removing Tool
4.11.1 Inserting
The milling head is equipped with a collet chuck for BT20x45° pull studs. The conical seat itself
is a taper of size 7:24. We use BT20 as the name of the conical seat. Please ensure that stand-
ardised spindle seats only start from size 30. Therefore, we cannot guarantee that the conical
seat with collet chuck of other manufacturers with a name such as SK20/BT20 or another pos-
sible future name, e.g. ISO 7388-1 - A 20
can also be used. Ask our Customer Services or use
the illustrated drawing in the technical data or use our online catalogue in which accessories for
the MH22V are listed.
Screw the collet chuck BT20 from Optimum into the conical seat.
Clean seat in the milling spindle.
Clean cone of the tool.
Open the spindle protection system so that the mechanical guard of the rapid holding sys-
tem can be unlocked.
Push up the spindle level and place the tool into the spindle.
Release the spindle lever again.
Close the spindle protection system again.
4.11.2 Removing
Open the spindle protection system.
Firmly hold the tool.
Push up the spindle lever.
Img.4-2:
Unfitting
