Safety
Version 1.0.2 - 2020-09-15
18
Translation of original instructions
GT25 | GT30 | GT40
EN
GT25_G
T30_G
T40_G
B_1.
fm
WARNING!
Live parts and moves of machine parts can injure you or others dangerously!
Take extreme care if you do not switch off
the surface grinding machine by turning off the master switch due to required works
(e.g. functional control).
1.14.1 Using lifting equipment
WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death. Observe the accident prevention regulations issued
by your Employers Liability Insurance Association or other supervisory authorities
responsible for your company.
Check that the lifting and load-suspension equipment are of sufficient load-bearing
capability and are in perfect condition. Fasten the loads carefully. Never walk under
suspended loads!
1.14.2 Mechanical maintenance
Remove or install protection safety devices before starting or after completing any mainte-
nance work; this include:
covers,
safety instructions and warning signs,
grounding cables.
If you remove protective or safety devices, re-fit them immediately after the completing the
work.
Check if they are working properly!
1.15
Accident report
Inform your supervisors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the quicker the causes can be eliminated.
INFORMATION
We draw your attention to specific hazards when carrying out work with and on the surface
grinding machine in the description of this work.
1.16
Electronics
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Disconnect the machine immediately if there is a malfunction in the
power supply!
Comply with the required inspection intervals in accordance with the factory safety directive,
operating equipment inspection.
The operator of the machine must ensure that the electrical systems and operating equipment
are inspected with regards to their proper condition, namely,
by a qualified electrician or under the supervision and direction of a qualified electrician,
prior to initial commissioning and after modifications or repairs, prior to recommissioning
and at certain intervals.