Safety
Version 1.0.1 - 2020-08-18
10
Translation of original instruction
DP33
EN
D
P
33_G
B.
fm
1.10
Safety check
Check the drilling machine before each start-up or at least once per shift. Inform the person
responsible immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation) and
after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the drilling machine
are legible (clean them, if necessary)
are complete (replace if necessary).
INFORMATION
Organise the checks according to the following table;
1.11
Emergency-stop switch
CAUTION!
The drilling spindle keeps turning for a short time even after actuating the emergency
stop switch depending on the preset speed.
1.11.1 Drilling table
Seats for T-slots are attached to the clamping table.
WARNING!
Risk of injury due to workpieces flying off at high speed. Securely fix the workpiece on
the drilling table.
General check
Equipment
check
OK
Guards
Mounted, firmly bolted and not damaged
Signs,
Markers
Installed and legible
Date:
Checked by (signature):
Functional check
Equipment
check
OK
Emergency-stop switch
After the emergency stop button is pressed, the
drilling machine must switch off.
Position switch of protective cover
V-belt
The drilling machine must not be switched on, if the
protective cover of the V-belts is opened.
Drill chuck guard position switch
The drilling machine may not switch on, if the drill
chuck guard is opened.
Date:
Checked by (signature):