Operation
Version 1.1.2 dated 2019-05-07
Page 270
Translation of the original instructions
F80 | F105
GB
F
80_F105
_GB
_6.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
6.5.4
Inserting a tool
INFORMATION
Before you can run a CNC program, at least one tool must have been created and
measured in the tool memory.
Change over to the mode <JOG>.
Press the "Offset" key on the
machine control panel.
Press the "Tool list" softkey
For the following working steps,
please proceed as described in
„Operation and programming“ of
the Siemens SINUMERIK 808D
Operation instructions.
6.5.5
Clamping workpiece and setting workpiece datum
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
When setting and using already created programs observe the safety clearance in order
to avoid collisions with the selected clamping means.
WARNING!
Risk of injury caused by workpieces flying off.
Clamp the workpiece in the machine
vice.
Make sure that the workpiece is firmly
clamped in the vise.
Img.6-3:
Clamping the workpiece
6.5.6
Manual tool change
ATTENTION!
Hold your tool if there is a tool inserted in the spindle.
Press the push button "Open/Close door" and open the sliding door.
Check that the LED on the pushbutton <K11>lights up.
Press - if necessary - the pushbutton <K11>. The manual tool change
is thereby enabled again.
Workpiece
Machine vice
K11
