Assembly
Version 1.0 2019-01-17
Page 47
Translation of the original instructions
B17Pro basic
GB
B17P
ro_b
asic_
G
B.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
Provide sufficient space for the personnel preparing and operating the machine and trans-
porting the material.
Also make sure the machine is accessible for setting and maintenance works.
Provide for sufficient backlight (Minimum value: 500 Lux, measured at the tool tip). In the
event of a lower level of lighting, additional illumination must be provided, e.g. by means of
a separate workplace light.
INFORMATION
The mains plug of the drilling machine must be freely accessible.
3.2.2
Assembly
WARNING!
Danger of crushing when assembling and installing the machine components.
Mounting of base and drill column
Position the base on the floor and
attach the column to the base. Fasten-
ing screws for the column have been
provided on the base.
Loosen the screw on the retaining ring
and remove the retaining ring and
toothed rack.
Img.3-1:
Assembly of the base
Mounting of the drilling table support
Position the worm gear in the support
of the drilling table.
Adjust the toothed rack within the table
support in a way that the teeth of the
toothed rack cam into the spiral wheel
of the support for the drilling machine
table.
Img.3-2:
Mounting of the drilling table support
INFORMATION
The longer untoothed end of the rack must point upward.
Push the drilling table support with the toothed rack on the drill column.
Push the retaining ring onto the upright and the rack.
Tighten the screw of the retaining ring slightly. Make sure that the drilling table support still
can be easily turned around the column.
Screw
Retaining ring
toothed rod
Drilling column
Stand
toothed rod
Clamping lever
Drilling table sup-
port
