Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: 1-888-553-3888, Fax: (602) 343-1489, Email: [email protected]
2.
Evaluation Board
The Evaluation Board for the BPR is used for ease of testing. It provides convenient
access to all 14 pins and the data output ports. Utilizing a zero-insertion force
configuration, the BPR can be mounted without the need for soldering as a user-friendly
interfacing solution. The EVB is mounted on a base plate. The base plate can be further
mounted to other structures using the four ¼-20 threaded through holes
2.1
Device Mounting Procedure
i)
Place the BPR onto the evaluation board as show in Fig. 2. Pay attention to its
orientation. The label P and N denotes the positive and negative RF output
ports.
ii)
Align pins down into pin chuck. Make sure that they line up and don’t cross
over.
iii)
Mount BPR to Evaluation board using the four
2-56
screws provided.
iv)
Once secured clamp pins down in pin chuck, as shown in Fig. 2.
Figure 2. BPR mounting procedure
4x 2-25
screws