BIOLINE
Manual for installation and use
OPTIKON 2000
6 INSTALLATION
6.1 INTRODUCTION
This section details the recommended procedure for installing and checking the
operational functions of the BIOLINE unit.
The operational checks, however, which are performed after the system installation
to verify equipment operation, must be performed exactly as indicated and should not
be regarded as recommended practice or encouragement for any diagnostic
procedures.
To bring your biometer in operation, a series of cable, footswitch and probe
connections must be made.
Follow the installation and operating instructions carefully in a step by step manner
and, within a short time, you will have gained all the knowledge needed for
successful operation of your biometer.
6.2 UNPACKING AND INSPECTION
This unit has been packaged to minimize the risk of damage in shipment. Unwrap the
package and examine the components. Handle all components with care during
unpacking. Use caution cutting the wrapping to ensure that the cut does not
penetrate the packing and damage the components. If external or internal shipping
damage is discovered, notify the carrier (mail, railways or forwarding agents) and
Optikon 2000 as soon as possible. Check the contents against the packing list and
notify Optikon 2000 immediately of any discrepancies.
6.3 INSTALLATION PROCEDURE
NOTE
The operator is responsible for cleaning and disinfecting probes and reusable accessories
The following procedure should be observed to install the system:
Position the instrument in a comfortable way.
Insert the footswitch jack (optional) in the rear panel.
Insert the AC/DC adaptor in the 220 volt socket and the 12 volt connector in the rear
panel.
Connect the biometry probe to the front panel.
Code 141002EN
6-1
26.10.05 Rev.0